← All install guides
Install: Garage door controller
Adds smart control and status to most standard garage door openers.
Tools needed
- • Ladder
- • Screwdriver
- • Included wiring
Setup time
30 minutes
Step-by-step
- 1Mount the tilt sensor on the top panel of the garage door.
- 2Wire the controller module to the opener's terminals per the product template.
- 3Plug in the controller and follow the app's Add Garage Door flow.
- 4Test open/close from the app; confirm the safety beep sounds before the door moves.
Common mistakes
- • Mounting the tilt sensor sideways — needs vertical orientation.
- • Skipping safety beeper — required for remote operation.
Troubleshooting
- • Reports Unknown status: recalibrate tilt sensor from the app.